NeoHub Binding

Documentation of the NeoHub binding Bundle

Introduction

The NeoHub binding allows you to connect openhab via TCP/IP to Heatmiser's NeoHub and integrate your NeoStat thermostats onto the bus.

For installation of the binding, please see Wiki page Bindings.

Binding Configuration

The binding polls each thermostat that is configured in your items, at the refresh rate (as set in the cfg file - see below).

Refer to the example below to see what you need to include in your openhab.cfg file:

################################ NeoHub Binding #####################################
#
# Refresh interval in milliseconds (optional, defaults to 60000ms)
#neohub:refresh=60000

# Set the NeoHub network address
#neohub:hostname=

# Set the port number for the NeoHub interface (optional, defaults to 4242)
#neohub:port=4242

Item Binding Configuration

Item strings simply consist of two components - the NeoStat device name (as set in the thermostat and in the mobile app, e.g. Office), and the NeoStat property (e.g. CurrentTemperature). Both parameters are only separated by a colon. Some examples are below.

Switch Heating_Office       "Heating Office"         {neohub="Office:Heating"}
Switch Away_Office          "Away Office"            {neohub="Office:Away"}
Switch Standby_Office       "Standby Office"         {neohub="Office:Standby"}
Number Temperature_Office   "Temperature [%.1f °C]"  {neohub="Office:CurrentTemperature"}

The following properties, and their associated item types are shown below. The R and RW in the description column indicate which properties are read only (RO) or read/write (RW).

Property	Type Supported	Description
CurrentTemperature	Number	RO Current room temperature
CurrentSetTemperature	Number	RO Current set temperature
CurrentFloorTemperature	Number	RO Current floor temperature
DeviceName	String	RO Returns the device name
Heating	Switch, String	RO Returns ON or OFF if heating is currently enabled or not
Away	Switch, String	RW Returns ON or OFF if thermostat is in away mode or not
Standby	Switch, String	RW Returns ON or OFF if thermostat is in standby mode or not