Skip to content

Protocol

Jump to bottom
Mygod edited this page May 15, 2020 · 10 revisions

Shadowsocks is a secure split proxy loosely based on SOCKS5.

client <---> ss-local <--[encrypted]--> ss-remote <---> target

The Shadowsocks local component (ss-local) acts like a traditional SOCKS5 server and provides proxy service to clients. It encrypts and forwards data streams and packets from the client to the Shadowsocks remote component (ss-remote), which decrypts and forwards to the target. Replies from target are similarly encrypted and relayed by ss-remote back to ss-local, which decrypts and eventually returns to the original client.

Addressing

Addresses used in Shadowsocks follow the SOCKS5 address format:

[1-byte type][variable-length host][2-byte port]

The following address types are defined:

  • 0x01: host is a 4-byte IPv4 address.
  • 0x03: host is a variable length string, starting with a 1-byte length, followed by up to 255-byte domain name.
  • 0x04: host is a 16-byte IPv6 address.

The port number is a 2-byte big-endian unsigned integer.

TCP

ss-local initiates a TCP connection to ss-remote by sending an encrypted data stream starting with the target address followed by payload data. The exact encryption scheme differs depending on the cipher used.

[target address][payload]

ss-remote receives the encrypted data stream, decrypts and parses the leading target address. It then establishes a new TCP connection to the target and forwards payload data to it. ss-remote receives reply from the target, encrypts and forwards it back to the ss-local, until ss-local disconnects.

For better obfuscation purposes, both local and remote SHOULD send the handshake data along with some payload in the first packet.

UDP

ss-local sends an encrypted data packet containing the target address and payload to ss-remote.

[target address][payload]

Upon receiving the encrypted packet, ss-remote decrypts and parses the target address. It then sends a new data packet containing only the payload to the target. ss-remote receives data packets back from target and prepends the target address to the payload in each packet, then sends encrypted copies back to ss-local.

[target address][payload]

Essentially, ss-remote is performing Network Address Translation for ss-local.

Clone this wiki locally