Prime Edition MkIII. Quick start

1. Download firmware binaries into your Prime Edition Mark III. Follow these instructions. ¹

   ¹ - this operation is typically not required when the T-Beam Supreme board comes with factory pre-installed SoftRF firmware.

2. Move your Prime MkIII into an area of good GPS/GLONASS/BeiDou/Galileo reception, turn on and leave nearby.

3. Connect your Tablet/Cellphone to SoftRF Wi-Fi Access Point.
   SSID: SoftRF-XXXXXX
   Key: 12345678
   

4. Open up a browser then proceed to this URL: http://192.168.1.1

5. A page like this should come up:
   

6. Open up Settings menu. Select NMEA UDP option. Press Save and restart button.

7. Disconnect from SoftRF AP and connect to internet.
   Install XCSoar app from Google Play.
   Re-connect to SoftRF AP.
   

8. Open the XCSoar app in Fly mode. Double tap the screen then select Config:

9. Select Devices:

10. Push Edit button then configure the device as follows:

11. Push Monitor button and see if your tablet/phone is receiving NMEA data from your Prime Edition Mark III:

12. Return all the way back to XCSoar main screen:

13. Swipe three times to the left to reach Radar View. When any other traffic ^{(SoftRF or OGN Tracker)} is around - you should see it on this screen: