Update USER_SETTINGS.h

Software/USER_SETTINGS.h

@@ -16,7 +16,7 @@
 //#define TEST_FAKE_BATTERY
 
 /* Select inverter communication protocol. See Wiki for which to use with your inverter: https://github.com/dalathegreat/BYD-Battery-Emulator-For-Gen24/wiki */
-//#define BYD_CAN          //Enable this line to emulate a "BYD Battery-Box Premium HVS" over CAN Bus
+#define BYD_CAN          //Enable this line to emulate a "BYD Battery-Box Premium HVS" over CAN Bus
 //#define BYD_MODBUS       //Enable this line to emulate a "BYD 11kWh HVM battery" over Modbus RTU
 //#define LUNA2000_MODBUS  //Enable this line to emulate a "Luna2000 battery" over Modbus RTU
 //#define PYLON_CAN        //Enable this line to emulate a "Pylontech battery" over CAN bus
@@ -42,7 +42,22 @@
 //#define CONTACTOR_CONTROL     //Enable this line to have pins 25,32,33 handle automatic precharge/contactor+/contactor- closing sequence
 //#define PWM_CONTACTOR_CONTROL //Enable this line to use PWM logic for contactors, which lower power consumption and heat generation
 //#define DUAL_CAN              //Enable this line to activate an isolated secondary CAN Bus using add-on MCP2515 controller (Needed for FoxESS inverters)
-#define SERIAL_LINK_RECEIVER_FROM_BATTERY  //Enable this line to send battery data over Modbus pins to another Lilygo
-#define SERIAL_LINK_TRANSMITTER_INVERTER  //Enable this line to receive battery data over Modbus pins from another Lilygo
+
+#define SERIAL_LINK_RECEIVER_FROM_BATTERY  //Enable this line to receive battery data over RS485 pins to another Lilygo
+//#define SERIAL_LINK_TRANSMITTER_INVERTER  //Enable this line to send battery data over RS485 pins from another Lilygo
 
 #endif
+
+/*
+ *   Using SerialDataLink
+ *   
+ *   for example, if inverter is BYD_CAN compatible and Tesla M3 bttery is used
+ *   
+ *   Inverter end:
+ *      #define SERIAL_LINK_RECEIVER_FROM_BATTERY
+ *      #define BYD_CAN
+ *      
+ *   Battery end
+ *      #define TESLA_MODEL_3_BATTERY
+ *      define SERIAL_LINK_TRANSMITTER_INVERTER
+ */