-
-
Notifications
You must be signed in to change notification settings - Fork 52
Slicers
github-actions[bot] edited this page Nov 1, 2024
·
14 revisions
Name | Multitool | Issue | Discussion | Notes |
---|---|---|---|---|
Cura | ✓ | As of 5.8, select new printer, select DraftShift Design, select the size from the voron list, allows up to 8 extruders | ||
OrcaSlicer | ✓ | As of 2.2 | ||
PrusaSlicer | ✓ | |||
Simplify3D | ? | |||
Slic3r | ? | |||
SuperSlicer | ✓ | See 2197 |
Printer -> Custom G-code -> Start G-code - all must be a single line
PRINT_START TOOL_TEMP={first_layer_temperature[initial_tool]} {if is_extruder_used[0]}T0_TEMP={first_layer_temperature[0]}{endif} {if is_extruder_used[1]}T1_TEMP={first_layer_temperature[1]}{endif} {if is_extruder_used[2]}T2_TEMP={first_layer_temperature[2]}{endif} {if is_extruder_used[3]}T3_TEMP={first_layer_temperature[3]}{endif} {if is_extruder_used[4]}T4_TEMP={first_layer_temperature[4]}{endif} {if is_extruder_used[5]}T5_TEMP={first_layer_temperature[5]}{endif} BED_TEMP=[first_layer_bed_temperature] TOOL=[initial_tool]
Printer -> Custom G-code -> Tool change G-code
M104 S{temperature[next_extruder]} T[next_extruder] ; set new tool temperature so it can start heating while changing
NOTE: add this as a second line if you use prime tower
G1 X{wipe_tower_x} Y{wipe_tower_y} F{travel_speed*60} ; Move to wipe tower before tool change
Printer settings -> Machine G-code -> Machine start G-code - all must be a single line
PRINT_START TOOL_TEMP={first_layer_temperature[initial_tool]} {if is_extruder_used[0]}T0_TEMP={first_layer_temperature[0]}{endif} {if is_extruder_used[1]}T1_TEMP={first_layer_temperature[1]}{endif} {if is_extruder_used[2]}T2_TEMP={first_layer_temperature[2]}{endif} {if is_extruder_used[3]}T3_TEMP={first_layer_temperature[3]}{endif} {if is_extruder_used[4]}T4_TEMP={first_layer_temperature[4]}{endif} {if is_extruder_used[5]}T5_TEMP={first_layer_temperature[5]}{endif} BED_TEMP=[first_layer_bed_temperature] TOOL=[initial_tool]
Printer settings -> Machine G-code -> Change Filament G-code
;Leave blank
Machine Settings -> Printer -> Start G-code - all must be a single line
PRINT_START TOOL_TEMP={material_print_temperature_layer_0} T{initial_extruder_nr}_TEMP={material_print_temperature_layer_0} BED_TEMP={material_bed_temperature_layer_0} TOOL={initial_extruder_nr}
Machine Settings -> Printer -> Tool n -> Extruder Start G-code
;Leave blank
Machine Settings -> Printer -> Tool n -> Pre tool change G-code - 5.9+
M104 S{material_print_temperature} T{extruder_nr}