Slicers

1. Slicer Software
2. Slicer GCODEs

Slicer Software

Name	Multitool	Issue	Discussion	Notes
Cura	✓			As of 5.8, select new printer, select DraftShift Design, select the size from the voron list, allows up to 8 extruders
OrcaSlicer	✓			As of 2.2
PrusaSlicer	✓
Simplify3D	?
Slic3r	?
SuperSlicer	✓			See 2197

Slicer GCODEs

Prusa

Printer -> Custom G-code -> Start G-code - all must be a single line

PRINT_START TOOL_TEMP={first_layer_temperature[initial_tool]} {if is_extruder_used[0]}T0_TEMP={first_layer_temperature[0]}{endif} {if is_extruder_used[1]}T1_TEMP={first_layer_temperature[1]}{endif} {if is_extruder_used[2]}T2_TEMP={first_layer_temperature[2]}{endif} {if is_extruder_used[3]}T3_TEMP={first_layer_temperature[3]}{endif} {if is_extruder_used[4]}T4_TEMP={first_layer_temperature[4]}{endif} {if is_extruder_used[5]}T5_TEMP={first_layer_temperature[5]}{endif}  BED_TEMP=[first_layer_bed_temperature] TOOL=[initial_tool]

Printer -> Custom G-code -> Tool change G-code

M104 S{temperature[next_extruder]} T[next_extruder] ; set new tool temperature so it can start heating while changing

NOTE: add this as a second line if you use prime tower

G1 X{wipe_tower_x} Y{wipe_tower_y} F{travel_speed*60} ; Move to wipe tower before tool change

Orca

Printer settings -> Machine G-code -> Machine start G-code - all must be a single line

PRINT_START TOOL_TEMP={first_layer_temperature[initial_tool]} {if is_extruder_used[0]}T0_TEMP={first_layer_temperature[0]}{endif} {if is_extruder_used[1]}T1_TEMP={first_layer_temperature[1]}{endif} {if is_extruder_used[2]}T2_TEMP={first_layer_temperature[2]}{endif} {if is_extruder_used[3]}T3_TEMP={first_layer_temperature[3]}{endif} {if is_extruder_used[4]}T4_TEMP={first_layer_temperature[4]}{endif} {if is_extruder_used[5]}T5_TEMP={first_layer_temperature[5]}{endif}  BED_TEMP=[first_layer_bed_temperature] TOOL=[initial_tool]

Printer settings -> Machine G-code -> Change Filament G-code

;Leave blank

Cura

Machine Settings -> Printer -> Start G-code - all must be a single line

PRINT_START TOOL_TEMP={material_print_temperature_layer_0} T{initial_extruder_nr}_TEMP={material_print_temperature_layer_0} BED_TEMP={material_bed_temperature_layer_0} TOOL={initial_extruder_nr}

Machine Settings -> Printer -> Tool n -> Extruder Start G-code

;Leave blank

Machine Settings -> Printer -> Tool n -> Pre tool change G-code - 5.10+

M104 S{material_print_temperature} T{extruder_nr}