Minor fixes and improvements, changes gradually trickling out across late December / January kits. No major incompatibilities with previous kits.
Fixes:
- Corrected dimensions of nut cut-outs in frame top bar - previously cut-outs were oversized, did not constrain nut and prevent it from spinning during tightening.
Improvements:
- Easier HotEnd installation / removal, printed cap-piece replaced with printed circlip.
- Easier X Endstop installation - requires two fewer spacers, and bolts will no longer protrude through printed part to rub against X belt.
- Increased size of wiring slot behind RAMPS board, easier to tuck excess wiring away.
- Increased size of wiring hole in rear top bar, should now have sufficient room for LCD wiring and extruder wiring - was previously only intended for LCD wiring.
- Improved printability of fan mount, removed need for support material during printing.
- Added starter PLA profiles for Slic3r and Simplify3D.