Docs. Add pvccase doc

doc/quickStart/pvccase/pvccase.rst

@@ -0,0 +1,49 @@
+#################################
+Red Pitaya Acrylic case assembly
+#################################
+
+Regardless whether you bought your Red Pitaya Acrylic case in a kit or as a separate add on, you will need to manually asembile it.
+
+***************************************
+Red Pitaya Acrylic Case asembly parts.
+***************************************
+
+.. figure:: rp_pvccase.jpg
+
+    Red Pitaya Acrylic Case asembly parts.
+
+It includes:
+
+    - 8 screws that close the housing
+    - 4 long brass standoffs and 4 short ones that hold the board
+    - 4 rubber feet for secure positioning on the desk
+
+********
+Assembly
+********
+
+1. Remove small, white plastic feet by pressing the clips at the top, with a small pair of pliers and push the feet down.
+
+    .. figure:: rp_pvccase_01.jpg
+
+        Bottom of the Red Pitaya board showing the plastic feet.
+
+2. Mount the brass standoffs as seen in the picture below:
+
+    .. figure:: rp_pvccase_02.jpg
+
+2.1 If you have the model where the 6 pin connector is present please use included white plastic washers.
+
+    .. figure:: rp_pvccase_03.jpg
+
+        Red Pitaya bottom pcb showing the 6-pin connector CN11
+
+    .. figure:: rp_pvccase_04.jpg
+
+        If CN11 connector is present use included plastic washers when mounting bottom part.
+
+    .. figure:: rp_pvccase_05.jpg
+
+        Red Pitaya showing use of white plastic washers for 6-pin connector CN11 clearance
+
+3. Stick rubber feet.

doc/quickStart/quickStart.rst

@@ -10,4 +10,5 @@ Quick start
    first
    SDcard/SDcard
    alucase/alucase
+   pvccase/pvccase
    troubleshooting/troubleshooting