04. AgOpenGPS Orientation
If (10) is consistently below 10 (and especially if it's at 1), you may have your ublox set incorrectly.
- Vehicle Configuration
- Vehicle Dimensions
- Antenna Configuration
- Steer Options
- Implement Configuration
- Attachment Configuration
-
Sections TODO
-
Attachment Options
For (1), top to bottom, they are:
- Time to turn on the section early before getting to the unapplied area (for start of row)
- Time to shut sections off, before getting to the applied region (for end of row)
- Time to keep going after applied area says they should turn off
- Work Switch Configuration
If Work switch is enabled, then choose if you'd like to have it engage manual or auto-sections. Similar for Steer switch.
Toggle at the bottom is for if you want "work" to be counted when the work switch is on, or off.
-
Sources Configuration TODO
-
Roll Configuration
- U-Turn Configuration
(1) the radius you can comfortably make a turn in, without binding the machine/drawbar/tractor/PTO etc
- Arduino Machine Module Configuration
- Pin Configuration
15 Tram Lines Configuration.
- Icons and Sounds Configurations.
- Steer Setup Wizard
- Charts
- Smooth AB Curve - takes out the noise
- Delete Contour Paths
- Delete Applied Area
- Webcam
- Offset Fix
- Start New or Open Fields
- Field
- Boundary
- Headland
- Tramlines
- Boundary Contours
- Recorded Path
- Steer Settings
- Gain Configuration
- Stanley Settings
- Pure Pursuit Settings
- Drive and Test
- Steer Module Configuration
- Steer Mode
- Steer Indicator
- Right Side
- Functions for AB Line Selected
- Flags
- Version / Section Paint Color
- Color Setting
- AB Line
- Autosteer Control
- U-Turn Control
- Create AB Line or Curve
- Create AB Line
- Create Curve
- Contour
- Snap to Pivot
- AB Line Edit
- U-Turn Skips
- Headland Control Buttons
