The fans?
#185
Replies: 1 comment
-
The pins are not reversed, but there is a chance the internal servo duct for the internal/external selection is reversed (or incorrectly installed). If you switch to internal/external or vice versa, and have the fans off, and it sounds like something is strangling a tiny electric motor than you have that problem. See #68 If you have that problem, also check it in the flashforge firmware. In my case it only worked correctly in the original firmware after I moved the duct door. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I have read more than one post here about issues with the fans in the ADM5 Pro—something about pins being reversed, etc. Whatever it is/was, has it been fixed in the most recent .05 Beta? If not fixed, is there something I need to do on my end? FYI, I print a lot of ABS, and I'm counting on the filtration of the ADM 5 Pro.
Thanks again for a GREAT mod.
Beta Was this translation helpful? Give feedback.
All reactions