Inverted text Fusion360/ UGS

[Strummerone]

Hi all.
Hopefully someone can help.
This is my first job...I'm using a home made but basic XYYZ configuration. (Router)
I'm trying to engrave some text onto some plywood (Test piece). Absolutely delighted with the results except for the fact that it reads inverted! It looks fantastic if viewed in the mirror.... Which is not the desired effect. Correct way round would be nice.

SET UP: Fusion 360 > design > some text > Manufacture> create Gcode. No issues.
Hardware / Firmware: Mks dlc32 running Fluidnc via wifi.
UGS > Setup > Wizard > Checked motor direction using the wizard >all ok.
UGS > Visualizer display reads correct and tracks the tool in the correct direction..
UGS > Tried reverse motor direction in setup, made no difference.
Any ideas would be great..