Replies: 3 comments 4 replies
-
|
It looks like you didn't get a complete response from the controller (it is chopped off at the end): I am guessing that either the USB cable or the Arduino is not of sufficient quality. First make sure you have a properly shielded USB cable. If you are using a cheap Chinese arduino clone, consider in investing in a genuine Arduino. |
Beta Was this translation helpful? Give feedback.
-
|
Yes I am using clone Arduino but 1st time this works perfectly fine but now
it's not connecting
…On Fri, Oct 6, 2023, 11:49 PM Joacim Breiler ***@***.***> wrote:
It looks like you didn't get a complete response from the controller (it
is chopped off at the end):
?
<Idle,WPos:2147
***connection closed ***"
I am guessing that either the USB cable or the Arduino is not of
sufficient quality. First make sure you have a properly shielded USB cable.
If you are using a cheap Chinese arduino clone, consider in investing in a
genuine Arduino.
—
Reply to this email directly, view it on GitHub
<#2330 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/BDCGXXM2LJJJRE32VAWEVA3X6BDS7AVCNFSM6AAAAAA5WFFRVWVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM3TEMJSGQ2DC>
.
You are receiving this because you authored the thread.Message ID:
<winder/Universal-G-Code-Sender/repo-discussions/2330/comments/7212441@
github.com>
|
Beta Was this translation helpful? Give feedback.
-
|
Did you find a solution for this. I am getting the same thing happening. Changed arduino board to a genuine board and tried a different cable with same results. The funny thing is that it was connecting fine and at some time stopped. Real head scratcher this one. |
Beta Was this translation helpful? Give feedback.
-
|
Can you activate verbose logging in the console (right click in the console and select it in the menu) and connect again. Paste the console output here |
Beta Was this translation helpful? Give feedback.
-
|
This is with verbose on.
|
Beta Was this translation helpful? Give feedback.
-
|
Yeah, the response from the controller is corrupted and is likely due to a bad USB cable or maybe a bad Arduino. Make sure that you are using a properly shielded USB cable without an extensions or USB hubs. |
Beta Was this translation helpful? Give feedback.
-
|
I was able to connect. I wish I could tell you why but I do not know what changed. Ugh. I hope this isn't temporary. Thank you for responding. |
Beta Was this translation helpful? Give feedback.
-
i am having "*** Connecting to jserialcomm://COM10:115200
Grbl 0.9j ['$' for help]
?
<Idle,WPos:2147
***connection closed ***"
this issue while connecting to UGS
please help me to solve this issue .
and i am using Grbl 0.9j and nighty build UGS
and arduino uno R3 board.
Beta Was this translation helpful? Give feedback.
All reactions