Z-Probe not working correctly

[dflores6073]

I have an Inventables X-Carve Pro 4x4. After messaging Joacim I was able to utilize a nightly build to connect UGS. I tried using the Z-Probe module with no luck. I set the probe about .25" from the touch plate and click on the Z reset button. At this point I initiate the probe and the spindle double-taps the z-probe. I then run the G0Z0 command and the spindle does not move. I tried to run it again by following the procedure above with the same results as before. I then do a manual z-probe setting by going as close to the surface as possible and reset the 0 for Z. At this point I run the G0Z0 command and it moved to where I had set the bit.

Things that I noticed, my project is set to inches yet the Z-Probe is set to MM. Does this make any kind of difference?
The Alarm Probe is on as well until I connect my probe then it turns off, but if it disconnected the Alarm comes no.