[RESOLVED] Enable DUAL Z on SKR 3 #13
-
|
How do we enable the dual Z on SKR 3 I have connected Stepper Drivers on Z and E1 ports on the motherboard. I want to enable then G34 for Dual Z Alignment. Can i get some help on this ? |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
Both are already enabled when selecting that board. There’s no need to edit anything other than Prusa_AIO_Configuration.h. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks, When i try to Auto Home it works perfectly and when i try to level the bed using the menu it fails. I get Probing failed. Printed Halted Error. When i do the Level bed it auto homes and then only the right side stepper moves a bit and an error is thrown. I have uploaded a video with this error |
Beta Was this translation helpful? Give feedback.
-
|
Check your wiring and ensure there is no binding on either side of your Z axis. It also looks like your X gantry is pretty far out of tram, so you’ll need to manually tram the gantry to the bed first before running ABL or G34. |
Beta Was this translation helpful? Give feedback.
-
|
I fixed the mentioned issues and i am able to do the G34 without any issues. but when i try to do a level bed it fails again. Uploaded video for your reference |
Beta Was this translation helpful? Give feedback.
Both are already enabled when selecting that board.
There’s no need to edit anything other than Prusa_AIO_Configuration.h.