ergoCub 1.1 S/N:001 – Does not start with left_leg-eb8-j0_3 eoprot_tag_mn_comm_status_managementprotocolversion error

[GiulioRomualdi]

Robot Name 🤖

ergoCub 1.1 S/N:001

Request/Failure description

I tried to run the interface but the robot doesn't start

Detailed context

This is the error

[ERROR] theNVmanager::Impl::ask() had a timeout for BOARD left_leg-eb8-j0_3 IP 10.0.1.8 and nv ID32 = 0x00000002 -> IND = 0, TAG = eoprot_tag_mn_comm_status_managementprotocolversion
[ERROR] theNVmanager::Impl::ask() had a timeout for BOARD left_leg-eb8-j0_3 IP 10.0.1.8 and nv ID32 = 0x00000002 -> IND = 0, TAG = eoprot_tag_mn_comm_status_managementprotocolversion
[ERROR] theNVmanager::Impl::ask() had a timeout for BOARD left_leg-eb8-j0_3 IP 10.0.1.8 and nv ID32 = 0x00000002 -> IND = 0, TAG = eoprot_tag_mn_comm_status_managementprotocolversion
[ERROR] theNVmanager::Impl::ask() had a timeout for BOARD left_leg-eb8-j0_3 IP 10.0.1.8 and nv ID32 = 0x00000002 -> IND = 0, TAG = eoprot_tag_mn_comm_status_managementprotocolversion
[ERROR] theNVmanager::Impl::ask() had a timeout for BOARD left_leg-eb8-j0_3 IP 10.0.1.8 and nv ID32 = 0x00000002 -> IND = 0, TAG = eoprot_tag_mn_comm_status_managementprotocolversion

Additional context

inteface.txt

How does it affect you?

No response

[filippoborgogni]

Hi @GiulioRomualdi !
The problem was made by the ethernet cable (E5) that connects the EB5 board to the EB6 board. In fact the connector on EB6 side was disconnected, we reconnected it to restore the ETH comunication.
Closing! 🚀

[GiulioRomualdi]

Thank you!