Find the last version on https://github.com/on7lds/
Latest version : 1.21 (aug 2021)
* split contfiguration files :
it is possible (but not manadtory) to move all [NextionDriver] settings
to a separate configuration file (use the -C option for this new file)
* minor corrections
TAKE NOTE:
the default filename or the users file (DMRidFile)
is changed from stripped.csv to users.csv as of V1.20!
The purpose of this program is to provide additional control for Nextion display layouts other than the MMDVMHost supplied layouts. It does this by sitting between MMDVMHost and the Nextion Display. This program takes the commands, sent by MMDVMHost and translates, changes, adds or removes these commands. On top of that, it can also process commands from the display and execute corresponding commands on the host.
Since the program has to read the MMDVMHost configuration file (MMDVM.ini or /etc/mmdvmhost on PiStar) to know the Layout (for setting the baudrate) and other parameters (i.e. for knowing the frequency and location), the parameters for the NextionDriver itself are also located in the MMDVM configuration file, in an extra section [NextionDriver].
As stated above, the NextionDriver program will change the commands as needed and adds extra info (e.g. temperature, TG's info, ...) and sends this to the Nextion display.
This program also checks the network interface regularly, and it will show the most recent IP address, so you can check if the IP address changed.
When the files 'groups.txt' and 'users.csv' are present, usernames and talkgroup names will be looked up and sent to the display. NOTE : both files have to be sorted in ascending ID order !
The program also has the ability of receiving commands from the Nextion display. This way, one can provide buttons on a layout and do something in the host when such a button is pressed. One could, for example, make a 'system' page on the Nextion with system info and buttons to restart MMDVMHost, reboot or poweroff the host, ...
Yes, it is possible (when NextionDriver is running) to start/stop/restart MMDVMHost with buttons on the Nextion display !
When the Nextion display is connected to the serial port of the modem, NextionDriver V1.03 and later is able to address that port. How does this work ? Normally, the data to the display goes directly from MMDVMHost to the modem, tagged as data for the serial port. The modem will then pass the data to the serial port. By enabling transparent data, we are able to inject data into MMDVMHost and we will tag it as data for the display (this can only be done by setting sendFrameType=1 in the configuration file).
Data from the Nextion (when pressing buttons) will be treated similar and will exit MMDVMHost as transparent data. IMPORTANT : the firmware of the modem has to pass data from the display to MMDVMHost for this to work!
