project.conf

#
# Copyright (c) 2017 Red Hat, Inc.
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#   http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#

#
# This file contains the configuration of the project. The comments that
# describe the values are followed by a commented out line that contains
# the default value for the corresponding parameter.
#

#
# The version of the project.
#
#version=master

[images]

#
# The names of the images built by this project are constructed from a
# prefix, a image name, and a project version. The image name is taken
# from the directory that contains the Dockerfile for that image. The
# version is taken from the above 'version' parameter. The prefix is
# taken from this parameter.
#
#prefix=ovirt

#
# The address of the Docker registry where images should be pushed. By
# default this empty, which means that images are stored in the local
# docker storage.
#
# A local registry can be created with the following command:
#
#   docker run -d -p 5000:5000 --restart=always --name registry registry:2
#
# Then, to use that registry, change this parameter as follows:
#
#   registry=localhost:5000
#registry=