Kobo Aura

Note that in this file, Kobo Aura refers to the original Kobo Aura, model N514, rather than the newer Kobo Aura variants.

See also

• Booting a Kobo Aura from SD
• Kobo Aura uboot

Hardware details

• model N514, board E606F0B
• i.MX507 (MCIMX507CVM1B)
• ED060XH3 panel
• eMMC
• TI PMIC for eInk (TPS65185)
• MSP430 embedded controller
• CyberTan WC121 SDIO Wifi
• ELAN eKTF2132 touch controller
• external µSD slot
• frontlight

TODO list

Multiple E-Book reader vendors (Kobo, Tolino) buy their hardware design and kernel from a common source: Netronix.

hwconfig

The kernel from Netronix supports multiple devices at runtime, but not through devicetree. Instead they use their own scheme based on a struct of parameters in a GPT partition.

see ntx_hwconfig.h

• decoder script that can display all known hwconfig values given an MMC dump.

MSP430 embedded controller / PMIC

• version info at reg 0
• #define NEWMSP (msp_id == 0xe916)
• the powerkeep feature
• MFD/regmap interface
• poweroff/reboot
• PWM/frontlight
• interrupts
• RTC
• watchdog(?)
• battery handling logic

GPIOs

• charger status (see ntx_charge_status)
• TLE4913 hall sensor
• status LEDs (ON, ACT does not work)
• Try driving the ON LED with PWM
• power key
• bypassed KPP

Keypad Port (KPP)

• Keypad DT node fsl,imx21-kpp. (u-boot pad configuration)
• Buttons (this table)

MMC

• IOMUX setup (uboot, kernel: SD/eMMC/Wifi)
• general settings like maximum clock frequency and bus width
• card detect pin
• eMMC power management
• Wifi power/reset/interrupt

E Ink support

In the Kobo Aura, the E Ink display is driven by the EPDC controller in the i.MX507 SoC and a TI TPS65185x "PMIC for E Ink® VizplexTM Enabled Electronic Paper Display".

• i.MX EPDC IOMUX setup
• i.MX EPDC driver
• E Ink panel modes
• TPS65185 MFD
• TPS65185 regulators
• TPS65185 temperature monitoring

Touch screen

HWConfig knows a number of different touch screen controllers. The Kobo Aura uses the ektf2132.

• touch interrupt/reset/power
• ektf2132; how similar to ektf2127 is it?

USB

• device mode
• host mode
• cable detection (ACIN_PG, ACIN_ID?)

i.MX drivers

• i.MX50 power management support
• i.MX50 CPU frequency scaling
• i.MX50 temperature sensor (chapter 53 in the reference manual)