eWine-orchestrator

A Node-RED workflow for connectivity management on IoT Gateways.

For installation instructions, please refer to Node-RED's official documentation.

The following npm modules are required:

Install them either locally, in the project folder:

npm install node-red-contrib-batcher
npm install node-red-contrib-ds18b20

or globally:

sudo npm install -g node-red-contrib-batcher
sudo npm install -g node-red-contrib-ds18b20

A configuration file is provided to load the runtime settings required for this project.

Launch Node-RED with the --settings|-s command line argument:

node-red -s settings.js

Connect DS18b20 to RPI and node-red.

Configuration device in GPIO

DS18b20 wire circuit :

 DS18b20 / breadboard (column(from right),row(from bottom) or a10,b22,etc)
 gnd last, 4th 
 vcc first, 3rd
 sig a4

Configuration device in RPI read the following document from page 11 (pagg. 1-10 not compatible DS18b20 wire circuit) :

 doc/adafruits-raspberry-pi-lesson-11-ds18b20-temperature-sensing.pdf
 configuration device on RPI: pag. 11-12
 script Python : pag. 13-15

Configuration device in node-red
1. run a bash shell
2. npm install node-red-contrib-ds18b20-sensor
3. for further information, read the doc here : https://flows.nodered.org/node/node-red-contrib-ds18b20-sensor

first shell #launch virt python: eWine-connectivity-manager/wifi_manager/interpreter/python_venv.sh
second shell #activate virt-python: cd eWine-connectivity-manager . .venv/bin/activate
third shell #launch node-red cd eWine-orchestrator sudo node-red -s settings.js