Bottom Plates didn't seem to generate correctly #61
-
I used the build mentioned in #46. When running Full output:
When attempting to open either I am actually not sure if this shape is accurate to the design of the dactyl keyboard. I assumed the bottom would be fully closed, but this looks more like a gasket that I could do without. When attempting to render this in OpenSCAD so I can export as an STL, I end up with a 2D model:
Any help would be appreciated! I recognize that this may be a case of me being unfamiliar with OpenSCAD. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
The "filled" base plate generation function is not yet implemented for "solid" engine. In the clojure version, they generate the plate by filling all the holes in the model: switch holes and screw holes, so that the projection in the xy-plane is filled up. Then extrude the projection and difference with the screw holes. |
Beta Was this translation helpful? Give feedback.
The "filled" base plate generation function is not yet implemented for "solid" engine. In the clojure version, they generate the plate by filling all the holes in the model: switch holes and screw holes, so that the projection in the xy-plane is filled up. Then extrude the projection and difference with the screw holes.