Skip to content

geoff-coppertop/cr6-config

Repository files navigation

CR6 klipper settings and macros

This repo provides the settings and macros needed to run a CR-6 SE that uses an SKR pico for the mainboard and an CAN connected ebb36 for the toolhead.

Important features

  • Printer definition

How to install

The instructions assume that you have a up to data and working moonraker installation. If not start with updating your moonraker first. There are two methods that can be used to install these configs as listed below.

Add updater section

Open your moonraker.conf and add

[update_manager cr6-config]
type: git_repo
channel: dev
primary_branch: main
path: ~/printer_data/config/cr6-config
origin: https://github.com/geoff-coppertop/cr6-config.git
managed_services: klipper

below the mainsail updater section.

Manual clone

SSH into your PI and run the following,

cd ~/printer_data/config/
git clone https://github.com/geoff-coppertop/cr6-config.git

Then open your moonraker.conf and add

[include ~/printer_data/config/cr6-config/moonraker.conf]

below the mainsail updater section.

How to setup

The setup process is completed by simply adding the following,

[include cr6.cfg]

to your printer.cfg file. Be aware the file will show up as read only. This was intended by use.

About

No description, website, or topics provided.

Resources

Stars

Watchers

Forks

Packages

No packages published