Swiss not Loading

[Akurie]

Good Day, I am running with a pi pico with .2v picoboot.uf2 latest Swiss loaded to a 126 Micro SD (FAT32) plugged into a GC2SD in slot A. I followed the instruction to the fullest extent and I keep Getting the CG IPL not Swiss. I am sure I might be missing something. Looking for guidance.

[Colrut]

When this happens it is usually a connection issue on the GC or Pico board. Check all the solder points carefully to make sure that none are bridged to other contacts. I have gotten tripped up where the heat sink presses on the IPL chip and the wires coming off of it. I run the wire behind/around the chip rather than over. On one build I put a bit of heat sink over it as well to relieve pressure and insulate.

Good luck

[Akurie]

Thank you for the advice, I will be looking into it soon.

…

On Thu, Jan 26, 2023, 11:47 AM Colrut ***@***.***> wrote: When this happens it is usually a connection issue on the GC or Pico board. Check all the solder points carefully to make sure that none are bridged to other contacts. I have gotten tripped up where the heat sink presses on the IPL chip and the wires coming off of it. I run the wire behind/around the chip rather than over. On one build I put a bit of heat sink over it as well to relieve pressure and insulate. Good luck [image: PXL_20230126_100652960] <https://user-images.githubusercontent.com/83892045/214896447-7c838f0a-58be-47bc-a47e-153fdbd57eb1.jpg> — Reply to this email directly, view it on GitHub <#751 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/A4A3G53JKZCA43SCHKQ3BJDWUKTBRANCNFSM6AAAAAARYGA3UA> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>