v1.13.9a

[deividAlfa]

• Perform manual flash sector size detection instead of relying on the reported size by the Flash register.
  This should fix the fake/clones that were working with previous versions.

• Fix bug in calibration settings screen where the PID would react when switching between Zero set/Sampling/Captured.
  This would cause a small power pulse into the tip, warming it up.

• If the oled poweroff option is enabled, keep it on until the tip is colder than 60ºC.

---

This discussion was created from the release v1.13.9a.

[jopl]

Dear Dave,
thank you againn so much for your work!
Just a subject to improvement ... I am thinking about incresing number of heating elements (for soldering tweezers, which have in my case 2 of them, working independently).
I drawn the schematic as well as PCB (the same dimensions, different connector /aviatic G16 - 7 pins/) to be able to test it (attached). I am trying to be as compatible as possible.
My intention is to have new profile for tweezers, selectable in the menu, which will be able to control 2 PWMs and read 2 thermocouples. All settings will be the same for both heating elements.
Do you think it is easily possible to integrate into the current firmware, please?
Untill now, I tested both PWMs (CH1 and CH3) are able to work together as well as 2 ADC INs.
Waiting for the PCB production at the moment.
Thx for reply in advance.
Regards, Josef.

Soldering_Tweezers_10_Schematics.pdf

[deividAlfa]

Of course it can be done, but my project only targets "official" controllers, not everyone's mods.
Looks nice, but please understand I can't make custom firmware for everyone, this should be your own work and your own fork, sorry!