V1 AIO PCB Set up for grabs

[pmgducati]

Hi Everyone,
I have been working on a AIO PCB set and have a few of my v1 PCBs that are in good working order and function perfectly. I don't need them anymore as I have made v2 of all the PCBs.

You can see them here:
https://github.com/pmgducati/Blue-Retro-AIO-Units

Here is the list of what I have:
Main PCB - Unpopulated
N64 - Complete with Controller Pigtails
Gamecube - Unpopulated
PCE - PCB Complete
PS2/PSX - PCB Complete
Sega Saturn - PCB Complete
NES - PCB Complete
3DO - PCB Complete

As I said they are all v1 PCBs. So there have been changes between them and the current PCBs. Here are the changes that have been made for V2 (for the most part my current housing models would need to be modified to fit these PCBs)
All - The DB25 connector has been moved 2mm closer to the edge of the PCBs for more exposure outside of the housing and create a better connection. Unified all perimeter dimensions and hole locations to be exactly same across all version (<0.5mm changes)
N64/Gamecube - The data Pad order has been reversed to avoid twisting cables when installing in housing
PCE - Swapped the SEL and OE Pads (In this case the v1 PCB must have the SEL go to OE and vice versa)
PS2/Saturn - Added a notch for wire clearance from Pads on bottom side of PCB
PS2 - Added a pad for 3V in from PS2 as some models don't play well with the 8V on the controller (For this PCB a jumper needs to be added to the 3V Pin on the DB25 connector)

I also have a v1 main housing and 4x system side housing tops that I will throw in.

Im just looking for covering parts and shipping, ~$50 shipped (unless international)