You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I would like to power a Lilygo ttgo t-call controller (esp32 + sim800) with LiPo battery (type 18650).
Under the board there is a jst-ph 2mm connector but, if I connect, the LiPo battery to this connector the board is not powered.
However, I discovered that if I connect together the battery via jst and the USB port to the PC the board is powered and then if I disconnect the USB socket the board continues to be powered only by the battery. Is this normal behavior?
If so, how can you power the board without connecting to a PC, in particular if I use the deep sleep mode, during which the board stops being powered and then, when it wake up, powered again?
The text was updated successfully, but these errors were encountered:
I would like to power a Lilygo ttgo t-call controller (esp32 + sim800) with LiPo battery (type 18650).
Under the board there is a jst-ph 2mm connector but, if I connect, the LiPo battery to this connector the board is not powered.
However, I discovered that if I connect together the battery via jst and the USB port to the PC the board is powered and then if I disconnect the USB socket the board continues to be powered only by the battery. Is this normal behavior?
If so, how can you power the board without connecting to a PC, in particular if I use the deep sleep mode, during which the board stops being powered and then, when it wake up, powered again?
The text was updated successfully, but these errors were encountered: