Home
You need to modify the board to enable the internal bootloader of the STM32F103.
- Start by unscrewing the front plate , and remove the board from the case.
- Remove the R28 resistor because it's disabling the bootloader standard mode and connect a 10K resistor between the boot1 pin and the ground as shown.
- Solder a wire to the Boot0 pin, and another to the VCC 3,3V pin. Connect the wires together. This can be removed after the STMDuino bootloader download
- Plug your TTL to Serial USB stick
- Plug the Miditech/Midipplus board into the USB
- Launch STM Flash loader demonstrator (if you don't have it , check the ST Micro. web site) and reset the Miditech/Midiplus board by by touching the RST tap point and the ground (for example the USB plug shield). As the chip is in bootloader mode, you will, or hear nothing...
- Connect TTL RX 1/TTL TX1 from the Miditech/Midiplus board to the TTL RX/ TTL TX of your serial USB converter. You can solder 2 wires to the pads clearly labelled on the board it self, or just hold the wires with the left hand and do the rest with the right one !
- Choose the serial port corresponding to your Serial to TTL interface in the list than click on "Next" in STMFlash
At this point, it is still time to stop. After that step, not return possible !!!!!
- You will see a red warning indicating that the firmware is protected, and going further will erase it. So, if you are really sure, click on "Remove protection". The existing Miditech/Midiplus firmware will be entirely erased.
- Click next, and choose the "midiplus4x4_boot20.bin" file (see in the root dir of the Git repository). This is the STMDUINO bootloader especially modified for the Miditech/Midiplus board to activate the USB DISC command (on PA8).
- Check "Optimize", "Global Erase", and "Verify after download", then "Next". The download will start, and if everything is ok, you will have a message confirming that the the update was done correctly.