| Property | Value |
|---|---|
| Manufacturer | Itead Studio |
| Product page | http://www.electrodragon.com/product/wifi-iot-relay-board-based-esp8266/ |
| Wiki page | https://www.electrodragon.com/w/ESP_Relay_Board_Hardware |
| Build flag | ELECTRODRAGON_WIFI_IOT |
| Voltage | 5v |
TODO
The Electrodragon ESP Relay Board is pretty easy to flash IF you do not follow their wiki, it's all wrong. Check the picture above and note that:
- Power the board from the 5V pin, GND to GND
- The RX pin in the header should go to your programmer TX pin and
- The TX pin in the header should go to your programmer RX pin
- The button labeled BTN2 is connected to GPIO0, so hold it down while powering the board, I've had better results keeping it down until the flashing starts
TODO