These stl files contain magnetic tents from 5 to 30 degrees, allowing for fast, screw-less tent swapping. You will need the original metal plates from the website for those to fit.
You will need to buy some 8mm x 3mm magnets on the side and simply just press fit them into the print.
NOTE://
- These tents will slide around on the desk if you have no desktop mat, corke or the like.
- Even with these mats and even with rubber pads, they are not as steadily fixated as the original. The 15 degree tent is conciderably more unstable than the 5 degree tent for reference.
This project is unlicensed. Do whatever you want with it.
Magnets are press fit into the outer holes. The mid hole is for not hitting a screw on the board. Use 8mm x 3mm magnets. The whole in the middle is just what I had laying around.
Add it to the plat with one quick snap-on.
The top of the tent have matching bumps to ensure perfect lock onto the metal plate
5 degree tent
5 degree tent
5 degree tent
5 degree tent
15 degree tent. Note that the tent may work okay-ish without magnets.
Adding pads will ensure better fixation, though still not as good fixation as the original tents with 4 feet.
15 degree tent.