You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
It seems like Orcaslicer is putting the Z-Hop, at least in the case of a spiral Z-Hop, in the wrong place between layers. I noticed this because I had timelapse enabled and noticed it would take the picture from that specified position and then go back to the last point to do the Z-Hop, and then being printing the next layer.
In the code segment here, you can see the G17 and G3 commands are inserted at the beginning of the next layer, after all of the different layer change and timelapse commands run, near the bottom of the snippet. I would expect that this is occuring prior to the layer change, near the top.
I have Z-Hop type set to Auto in Orcaslicer. Let me know if additional information is useful in diagnosing this issue.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello,
It seems like Orcaslicer is putting the Z-Hop, at least in the case of a spiral Z-Hop, in the wrong place between layers. I noticed this because I had timelapse enabled and noticed it would take the picture from that specified position and then go back to the last point to do the Z-Hop, and then being printing the next layer.
In the code segment here, you can see the G17 and G3 commands are inserted at the beginning of the next layer, after all of the different layer change and timelapse commands run, near the bottom of the snippet. I would expect that this is occuring prior to the layer change, near the top.
I have Z-Hop type set to Auto in Orcaslicer. Let me know if additional information is useful in diagnosing this issue.
Beta Was this translation helpful? Give feedback.
All reactions