-
|
I notice the flow rate is too low after bridging, leaving some underextrusion in exterior walls. Is there a way I can adjust the flow rate of the highlighted section?
|
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
I think I've found it. After reading about the bridge vs overhang detection issues in #2231 I tried adjusting the overhang speeds. The flow rate (and speed) is affected by the 25-50% overhang speed setting for this short section of exterior wall after bridging. I suppose I expected the external bridge speed or simply the exterior wall speed should apply here instead of the 25-50% overhang speed.
|
Beta Was this translation helpful? Give feedback.
I think I've found it. After reading about the bridge vs overhang detection issues in #2231 I tried adjusting the overhang speeds. The flow rate (and speed) is affected by the 25-50% overhang speed setting for this short section of exterior wall after bridging.
I suppose I expected the external bridge speed or simply the exterior wall speed should apply here instead of the 25-50% overhang speed.