Feature request: Temperature setting for ironing

[RobXXR]

I like to run my BBL X1-Carbon fast
I have the 3rd party nozzle/hotend with 3 holes for better heat transfer to the filament.
So I run a 0.6 mm nozzle, 0.4 mm layers, print temperature @ 135 C for PLA, which is the maximum the heater can provide
It goes fine, but when I add ironing to my print too, I always get heat creep and the filament gets stuck so, I have to take the extruder and nozzle apart to clean out the stuck filament.
Would it be possible to add a temperature setting, just for ironing?

[Killrsheep]

Not only that, for certain materials like matte and silk I've noticed that i can get good layer adhesion with some temps BUT if im ironing the print, the top ironed layer will look great if i manually reduce the temperature to another setting while its ironing

[TheDIYGuy999]

I think this is a good idea, because Ironing tends to clogging on Bambu Lab printers. Another helpful option could be lifting the nozzle ab it for ironing, let's say 0.05mm and then increasing the flow a bit instead

[BlueByLiquid]

I would like to add so many settings to ironing including the temperature settings. I'm happy to do it myself but new to orca slicer dev and not sure where to start and no one responded to even point me in the right direction for where ironing is handled in Orca and I don't have time to fully do a deep dive in getting started on Orca dev and can't find any resources.