Replies: 5 comments
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
I'm also trying something with exposed infills and it would be good if this option was available like in Prusa/Superslicer.
|
Beta Was this translation helpful? Give feedback.
-
|
Slicing the HeadAmame phones with prusaslicer/superslicer or bambustudio I had no luck - there are always "holes" on the surface underneath (or over) the infill body part touching the shell part - not only the infill anchor problem. Check your sliced model - you'll find the holes. Only possible way to properly slice it was with Cura. |
Beta Was this translation helpful? Give feedback.
-
|
anyone solve this? |
Beta Was this translation helpful? Give feedback.
-
For a print I'm doing I need to set the infill anchor to 0 and I don't seem to be able to do that in bambu studio. If there was a way to expose the setting from prusa slicer that would be amazing!
Beta Was this translation helpful? Give feedback.
All reactions