Mainsail UI

[dweenz]

I have just started with Orcaslicer and love it however when I use it to connect to my printers, if I do not add the port number :7126, and :7125 after my host ip I cannot send the print to the correct printer. I am running linux on a NUC with 2 printers connected. If I do add the port number I can send prints to each printer properly but cannot use mainsail in the Orcaslicer app as it shows a different ip than the one I have entered but it also shows everything is connected properly just no access to moonraker UI mainsail. I'm fine with it but if there is something I am missing it would be nice to know.

[AmshaSharam]

On printer network tab config-> Hostname, ip or url : you put ip: port of printer where files go ex: 192.168.1.45:7125
on "Device ui you put only the ip of interface : ex: 192.168.1.45

[dweenz]

Thanks I did eventually figure it out by trial and error but you are exactly right.

[Dwall36b]

I was stumped on this. Thank you for helping me out! I've also shared this to help a few others.